What did you do to your truck today?

[bobkyle2]

welll my girlfreind loaded her dirtbike in my f150 and followed me in my f250(no plates or insuraces lol) to another town to moved a house trailor to my buddys property 25miles away..it was a blast pulling a 14x70 house trailor with my f250 specially with half the town hatin on my truck becosue they said it wouldnt pull it... i could have pulled like 4 more behind it

then my girlfreind took my f150 and took her bike to some of her familys property and rode forawhile....while i was moving that trailor... when i got home i realized i had 2 dirty ass vehicals...lol

 

[OldCracker29]

I finally dropped that trailer and unloaded all of my equipment this morning.

 

[drperry]

Well today is Tahoe TLC day. It is going on another trek to Montana on Tuesday.

-Oil change (Valvoline Synthetic)
-Fuel filter
-Tire rotation
-Need to finish adjusting her amps for the trip, wish I had time to replace the sub

Done!

Sub is blown in the Tahoe

New Kicker Comp on order!

Already? Man... I knew kicker had issues now and then, but that's rediculous!

 

[RedRider]

Took it back to paint shop so another detailer could look at it.

 

[Fordfanatic101]

nothing yet

 

[che22879]

Drove the 05 to work. Drove the shop truck (87 F250 460 runs on propane) to pick up wheels and drove the 99 to get lunch. Good day for me!

 

[Bernie]

Trying to get my new alarm installed but can't find a wiring diagram that shows how the door pin switches are wired to the interior lighting control module. I need to know the wire colors from the switches (and if they just ground or if they're hot) before I can wire in the alarm. Since the switches are installed in the side of the fwonking dash I'd rather not have to pull the dash apart to see the damn wires.

And... I have what I thought was the full set of wiring diagrams for the truck, but of course it doesn't include that little section.

 

[nubuilder]

Trying to get my new alarm installed but can't find a wiring diagram that shows how the door pin switches are wired to the interior lighting control module. I need to know the wire colors from the switches (and if they just ground or if they're hot) before I can wire in the alarm. Since the switches are installed in the side of the fwonking dash I'd rather not have to pull the dash apart to see the damn wires.

And... I have what I thought was the full set of wiring diagrams for the truck, but of course it doesn't include that little section.

Bernie, all I have is a Chilton repair manual that you can buy just about anywhere. I'll look, but I don't think it will be of any help.


Drove the S10 to school and home. And then filled it up. $30 and just shy of 11 gal. to come to 20.3mpg...I hope it doesn't get any worse.
So I've now spent $90 in 2 days to go 500 miles between both trucks.
Took the motorcycle for a spin, about 40 miles, and thank God it was sunny out, after dumping some Sta-Bil in it. I like to run a tank with it mixed in before parking it. That way I'm sure it is into all 4 carbs.

 

[Bernie]

Trying to get my new alarm installed but can't find a wiring diagram that shows how the door pin switches are wired to the interior lighting control module. I need to know the wire colors from the switches (and if they just ground or if they're hot) before I can wire in the alarm. Since the switches are installed in the side of the fwonking dash I'd rather not have to pull the dash apart to see the damn wires.

And... I have what I thought was the full set of wiring diagrams for the truck, but of course it doesn't include that little section.

Bernie, all I have is a Chilton repair manual that you can buy just about anywhere. I'll look, but I don't think it will be of any help.

Thanks Matt, but I finally found the info online on an alarm installation web site.

 

[Moeman]

Went deer hunting and came home empty.