What did you do to your truck today?

[ScottyBoy]

I let my truck sit since Thursday without starting it and now my battery was totally dead this morning when I went to start it. The battery has been goin dead quite fast lately, I noticed it went dead when I was installing my fog lights and had the door open and interior lights on for maybe 2 hours at most. I thought that was a bit odd that it died so fast and now dying this fast just from sitting, I think its time for a new battery. I'll be starting a new thread to get some opinions.

 

[dirtyoldman]

I removed the big Chevrolet/Suburban badge from the rear door....

However,I can still see where the paint is slightly darker where the badge was,any ideas how I can remedy this?

 

[04SilveradoMykk]

Thats all you did.... noob.

Nice work! So can the SOTP feel any difference?

Yea, it's nice... I spent so much time & planning to make this engine a high RPM screamer to take advantage of the 3200rpm stall & 4.1 rear gears that I really wasn't paying any attention to the sub-2000rpm torque. And when I'm around town cruising with the TCC locked occasionally the engine would want to buck or surge.

Now that I lowered the peak power RPM and really juiced up lower end torque, no more problem

 

[dietz4ibanez]

Took it hunting

 

[ScottyBoy]

I removed the big Chevrolet/Suburban badge from the rear door....

However,I can still see where the paint is slightly darker where the badge was,any ideas how I can remedy this?

Looks good Gramps. Not sure if theres anything that can be done about the paint fading though.

 

[Stumpuller6.5]

took the drive pulley off the whipple and took it to the machine shop to get a smaller one made.

 

[dietz4ibanez]

filled up the bed with rotors and mower blades

 

[Zembonez]

I removed the big Chevrolet/Suburban badge from the rear door....

However,I can still see where the paint is slightly darker where the badge was,any ideas how I can remedy this?

A little compound and wax should do it. That looks really good!

 

[Zembonez]

All I did was walk by mine today.

 

[daddy]

took the drive pulley off the whipple and took it to the machine shop to get a smaller one made.

MOAR BEWST!!!!