Quad beam setup

[1994Chevy350]

I am looking for a write for the quad beam headlight mod, I don't have hids, I have gmt400. Looking for something that can be done by A wiring challenged person

 

[thunderstruck]

If you know how to use wire strippers and a crimping tool, you can do it. If not, get a six pack and a friend to do it for you.

The Painless 30802 kit is good quality and color coded, but overpriced. You can do it yourself with a 30-amp relay, some ~14awg wire, and wire connectors.

http://www.truckmodcentral.com/forums/showthread.php?t=2502

You also don't have to connect the relay to the battery, you can just go to one of the posts in the underhood fusebox.

 

[700 sportsman]

Yep, it isn't too hard if you can read/follow directions. But it does make a HUGE improvement over stock, even without hids.

 

[1994Chevy350]

What colol wires am I looking for? For the low beam and high beam? I'm Gunna try and do it this week sometime

 

[700 sportsman]

Brown low, green high I do believe.

http://www.gmt400.com/forum/showthread.php?122-4-Hi-Headlight-Mod

Also I just took out the headlight, not the signal too.

 

[thunderstruck]

You don't have to remove the headlight, you can tap into the wires in the wire loom running across the driver side fender, nearby the evap canister.

 

[PenguinLTZ]

 

[thunderstruck]

Those are fucking crap.

 

[PenguinLTZ]

I did that just for you, Kyle

 

[BHB]

When I get an electrical part, and those are included, I smash them on the floor with a hammer.