Power steering

[Alljackedup408]

Soooooo... now advice here???

Plasma cutter.

let me get right on it. hell..at least itll be off.

You did NOT say it had to be good advice.

 

[Cowboy Cadillac]

A good set of wrenches and a small hammer. They are a little (M*#%&r F^&@#*%G) stubborn but they do come out. I used a cresent wrench( t'umb wrench :for Moeman) to take mine out as I was nowhere near proper tools.

 

[Cowboy Cadillac]

Be careful when re-tightening them though.. . that where mine was leaking from the first time.

 

[Alljackedup408]

Be careful when re-tightening them though.. . that where mine was leaking from the first time.

how did you tighten them? Just slowly and put alot of pressure on em?

 

[Cowboy Cadillac]

The rubber seals leaked in mine because the holes were slightly bent from the aformentioned struggle to remove the bolts.

 

[Stumpuller6.5]

remove with impact.

 

[Bigredmariner]

Brian I think that the adapter on the pressure line also unscrews, so you have to loosen the two bolts as well as the hex adapter that the high pressure line screws into. Look at that, it's been a long time but I think that correct.

 

[Cowboy Cadillac]

Brian I think that the adapter on the pressure line also unscrews, so you have to loosen the two bolts as well as the hex adapter that the high pressure line screws into. Look at that, it's been a long time but I think that correct.

If you dont remove it you'll be a long time trying to seperate the pump and resevoir

Nevermind I looked at pics..your all good

 

[Alljackedup408]

good news... one bolt busted free.. buddy is comin over to help me hold the pump while i tap the wrench with a hammer for the other one. The kit came with a bunch of seals... seals go on those 2 bolts as well???

 

[Bigredmariner]

Hey do a damn write up so the next poor bastard isn't pulling his hair out like you are.