B
batman
Guest
you mean like the jump and the other vids i posted????ok guys....i got the u-joint replaced without having to use old parts...i found that a 353 mastercraft bastard joint actuaqlly fits!!! hhhoooorrrraaaaayyyyy!!!!!!! got it all together and she's doing fine for now...still gonna have the shaft made though...that little shaft just doent get the job done....lol.....![]()
Obviously it does if it's the u-joint that died and not the shaft
Your driveshaft could probably use a healthy balancing
Or a new driver![]()
............got to have the better shaft..i was lucky this was only a u-joint this time..the yokes are geting worn on the shaft and the rearend..so i'm gonna have them all made when i get the driveshaft done...i had to limp it up to town in 4high today and change it in the parkinglot at orielly's auto..
![]()
A bad u-joint can wear out the yoke...
Maybe some excessive wheel hop made your rear axle rotate a touch, putting more stress on the joint.






............got to have the better shaft..i was lucky this was only a u-joint this time..the yokes are geting worn on the shaft and the rearend..so i'm gonna have them all made when i get the driveshaft done...i had to limp it up to town in 4high today and change it in the parkinglot at orielly's auto..