ScottyBoy
No, that's not a banana in my pants.
You bein sarcastic or you talking abou to put light to the ambient light sensor? If so, I have shined a light into that sensor. If you were talking about duct taping a light as my DRL, then
My DRL's quit working, any ideas?
- Thread starter ScottyBoy
- Start date
You bein sarcastic or you talking abou to put light to the ambient light sensor? If so, I have shined a light into that sensor. If you were talking about duct taping a light as my DRL, then
- Joined
- May 17, 2009
- Posts
- 57,295
- Reaction score
- 36
Just trying to help.
- Joined
- May 17, 2009
- Posts
- 57,295
- Reaction score
- 36
ScottyBoy
No, that's not a banana in my pants.
Tobias, go check your parking brake for me, will ya? 
I just need to know if the parking brake light is supposed to blink or be steady lit.
I just need to know if the parking brake light is supposed to blink or be steady lit.
Last edited:
Tobias, go check your parking brake for me, will ya?
Mine blinks when applied. Yours is behaving normally.
ScottyBoy
No, that's not a banana in my pants.
Tobias, go check your parking brake for me, will ya?
Mine blinks when applied. Yours is behaving normally.
Thanks.
ScottyBoy
No, that's not a banana in my pants.
Ok, I think I found my problem. For some reason the wire from the BCM wasn't triggereing the relay to turn the lights on. I applied 12v to terminal 30 on the relay and the lights came on. I couldn't for the life of me figure out why the BCM wouldn't be turning the lights on. So this morning I had a brain fart. I decided to unhook the battery for a few minutes to try and "reset" the BCM. And it worked! My lights are back to normal now, functioning like they should. So everything is all straight now. Thanks everyone for all your suggestions (except for putting a fwonking flashlight on my hood
).
).
Draenor
KILL ALL HUMANS!!!!
Seems like the BCM had a brain fart too.
Good thing this was an easy fix.
Good thing this was an easy fix.
