Jesse S
Full Access Member
A friend had these tall boy aftermarket valve covers ...
Think I like the no name factory GM grooved covers better ..
Do a powder coat finish in satin black and net a back to new look ..
IH 54 R-100 4X4
- Thread starter Jesse S
- Start date
A friend had these tall boy aftermarket valve covers ...
Think I like the no name factory GM grooved covers better ..
Do a powder coat finish in satin black and net a back to new look ..
Jesse S
Full Access Member
Not a whole lot of room back there ...
Even the shorty covers might have fitment issues ??
Even the shorty covers might have fitment issues ??
Jesse S
Full Access Member
I don't want to notch the firewall .. Really I don't !!
I'm real close to shooting the Bed Liner on it, still got the center section to work ...
I'm real close to shooting the Bed Liner on it, still got the center section to work ...
OldCracker29
I've been knocked down drug out and left for dead
Although I like the logo ones...except for the visible welds, I think the grooved ones would look better.
Jesse S
Full Access Member
The choice has been made ...
Will use the GM cast shorty covers ... The price was much less than the Bowtie tall covers ...
And I found a 4 bolt main 454 block ... This will change how the motor will be built ... Thinking about doing a stroker net 496 cubes ...
" Get the chickens & kids out of the street for here he comes "
Will use the GM cast shorty covers ... The price was much less than the Bowtie tall covers ...
And I found a 4 bolt main 454 block ... This will change how the motor will be built ... Thinking about doing a stroker net 496 cubes ...
" Get the chickens & kids out of the street for here he comes "
OldCracker29
I've been knocked down drug out and left for dead
Jesse S
Full Access Member
Getting mighty tired of sanding .. !
Looking good.
OldCracker29
I've been knocked down drug out and left for dead
I bet you are, but all of your effort is going to pay off in the long run. Looking sweet!
Jesse S
Full Access Member
Doesn't look all that bad, kind of a factory custom valve covers.
I like them better than most of the aftermarket's ..
Powder coat gave somewhat of a new look, they was a bit rough to start off with ..
Last edited:
