Getting my truck back.

[gmctrucks]

The word is that the wife's MPV van should be ready today it's been at the body shop I miss my truck and I need to start to put on all my brand new front and rear lights I bought for it and get to finding out why it not turning over when hot which im sure you guys have read that post im just happy im getting her back.

She has to take it since Nasa just doesn't let anybody in so I can't pick her up. I almost bought some Billet wheels for it im still debating on them the only thing I don't like about them is I would have to polish them with Mothers and my wheels are ARE that have a plastic coating on them the car wash gets them clean when I take it to get detailed. Can you tell that im bored I fell asleep at around seven last night so now im wide awake.

Body shops sure charge a lot the van didn't even have much wrong with it and the bill is a little over $2100,00 im hoping the owner is going to give me a break on my $250.00 decutable I have sent him a many of cars will see today I bet im going to have to pay something if so im not sending nothing more to his shop my step daughter just had work done on her truck some months back.

 

[Texas Jim]

I know you are ready to have your truck back....
Don't blame you a bit....

 

[OldCracker29]

 

[bobkyle2]

 

[buRRp]

 

[gmctrucks]

OK guys we picked up the MPV first thing we noticed was the inner fender liner was hanging down they forgot to place some plastic bolt in place then on the rear tailgate they covered up to holes where a MAZDA emblem goes and the body man said there was no holes there.

Next the rear outside sliding door handles were broken so I bought new ones so they could put them on well the body man messed up again and removed the front inner door panel and said he didn't well we knew he did because the door panel had grease all over the it and it was missing a gray plastic insert/bolt that holds the rubber seal and panel on the bottom of the door which was hanging down then when my wife said hey guy the plastic screw has to be gray to match the door panel he said no it doesn't well my wife had to show him the other door because he put on a black one.

Now when he replaced the back handles he left grease all over the back panels as well which she had them clean it up. So the wife took off to gas it up and noticed that on the front door panel that he said that he didn't remove was missing a plastic cover that one removes to take off the panel. I called them and told them to order it with the gray plastic bolt then the wife found it in the back seat so we drove back and told him look we found it and your body man said he didn't touch the door.

((I told them that I don't want them to drill new holes for the Mazda emblem he said they could use two sided tape is that stuff good???)) I tell you some people take no pride in there work now the shop is nice and the owner is cool it's just hard to find good help.