Turn Signal Flasher with LED Bulbs

KillaF150

I'm Ron Burgundy?
Joined
Nov 24, 2009
Posts
3,814
Reaction score
0
Location
Conway, AR
I'll also be converting all my bulbs to leds. ebay has some, and so does the lo-cal advanced auto :dunno:
 

nubuilder

Why buy new when you can restore?
Joined
Mar 10, 2010
Posts
10,154
Reaction score
4
Location
La Crosse, WI
I contacted an eBay seller directly. The only reason I went with them is because they had all the bulbs I wanted.

I've looked at other sites (superbrightleds.com), but they are twice as expensive.

On the upside, I did get my reverse bulbs in. Now my reverse lights match my lightbar. The mismatch really bugged me. The LEDs are a lot dimmer than the regular bulbs. I took a picture (at night) and you can clearly see the regular bulb overpowers the LED. I'll post the pic tomorrow.

I'm waiting for my new headlights, parking, and corner lights (also off eBay) and I'll be ordering some Anzo 911019 taillights tomorrow.
send_binary.asp

2LBCLH-C1094-TM1.jpg


Sorry for the big pic. I tried to change it.

Could anyone tell me if this flasher would solve my hyper-signals?
It is a Blazer FL29. $11.99 at AutoZone and O'Reilly.
 
Last edited:

nubuilder

Why buy new when you can restore?
Joined
Mar 10, 2010
Posts
10,154
Reaction score
4
Location
La Crosse, WI
I got my LEDs from hidlightsusa.com. I found them on eBay and ended up ordering through their website. I think all their bulbs come in packs of 2 (at least all mine were).

I got all the bulbs I wanted (14 bulbs total) for $91 shipped.
1x 194 white $5.98
1x 194 amber $4.98
2x 1157 amber $25.96 ($12.98 each)
2x 3057 red $23.96 ($11.98 each)
1x 3056 white $15.98

Like I said before, I got my reverse lights in last night. I'll try to post the pic showing the difference between LED and standard bulb. I took it at night so it really isn't that clear.

I installed my front corner bulb on the passenger side (I'm just doing the one side for comparison reasons for now) and my 2 red taillight bulbs on the passenger side. The corner bulb is fine, but the one taillight bulb (since only one of the two actually blinks/gets brighter) is being a little weird. Right now it blinks with the turn signal, but does not come on when the lights are turned on (basically when it is in the "running light" mode). I don't know if it works when I push the peddle yet. I'll check that tonight. I'm going to take it out and turn it around. Supposedly some LEDs only work one way (that's the way my reverse lights were; had to flip the one around). We'll see what happens.

I sent back the 2 packs of 1157 amber bulbs (that turned out to be red) and the 1 pack of 3057 that had discoloration on the one wire this morning (using USPS Flat Rate box; hope they survive).

For future reference, the Blazer FL29 electronic flasher (its a 4-pin model) works perfectly.

Thanks KillaF150!
Any comments on the taillights?
 

nubuilder

Why buy new when you can restore?
Joined
Mar 10, 2010
Posts
10,154
Reaction score
4
Location
La Crosse, WI
Got my one taillight fixed. The previous owner had put a crap load of bulb grease in the sockets. The grease had hardened enough to not conduct electricity. I just scrapped out a little and now the bulb functions properly.

Here are the pics comparing the reverse lights. The camera was acting stupid and half of the one picture was just all gray so I cropped it. You can barely see on the left side the regular bulb. It's hitting the white house and then you can barely see it hitting a fence. Basically there was enough light for the camera to pick up on the regular bulb and not at all on the LED. Looking out the back window it definitely isn't as bright, but it's not bad.
 

Attachments

  • 100_0290_2.jpg
    100_0290_2.jpg
    11 KB · Views: 4
  • 100_0288.jpg
    100_0288.jpg
    31.7 KB · Views: 7
  • 100_0289.jpg
    100_0289.jpg
    62.6 KB · Views: 6
B

Bernie

Guest
Got my one taillight fixed. The previous owner had put a crap load of bulb grease in the sockets. The grease had hardened enough to not conduct electricity. I just scrapped out a little and now the bulb functions properly.

Here are the pics comparing the reverse lights. The camera was acting stupid and half of the one picture was just all gray so I cropped it. You can barely see on the left side the regular bulb. It's hitting the white house and then you can barely see it hitting a fence. Basically there was enough light for the camera to pick up on the regular bulb and not at all on the LED. Looking out the back window it definitely isn't as bright, but it's not bad.

Does WI have state inspections? If it does, that will probably fail you.
 

nubuilder

Why buy new when you can restore?
Joined
Mar 10, 2010
Posts
10,154
Reaction score
4
Location
La Crosse, WI
No we don't have inspections. Why would I fail it? Do they measure lumens of output?

It lights up just fine. You can see it easily outside of the vehicle. I can still see behind me. Just not quite as bright. Its just that cameras suck at capturing low levels of light; especially when it is pitch black out.

Just ordered my taillights (pictured above). I lucked out. I put off ordering them and then today when I went on StreetSideAuto they had a $5 off $55+. Got them for $62.89!
 

Staff online

Members online

Latest posts

Forum statistics

Threads
28,836
Posts
1,109,352
Members
4,800
Latest member
SpeakerMan
Back
Top