Round wheel in a square hole

[Bowtie2Sierra]

I bought a new truck a few weeks ago (I'll start a thread with pics eventually). I ran across some wheels that I like but they are 20x10 with a -24mm offset. I'm horrible with figuring out the fitments on these trucks since some brilliant designer decided to make square wheel wells.

Does anyone know if I can run this size of wheel with a 1.5" level up front and 1.5" BL?

 

[Zembonez]

WOW. That wheel will stick out far enough for ME to touch it from here. 20x10 needs a lot of positive offset or it will crush the inner fender on even slight turns.

 

[daddy]

WOW. That wheel will stick out far enough for ME to touch it from here. 20x10 needs a lot of positive offset or it will crush the inner fender on even slight turns.

Agreed. You'll be closer to +35.


What wheels was it?

 

[Bowtie2Sierra]

Damn...I was worried you guys were going to say that.

They are Weld Dunes.

 

[RebelThunder]

What size tire?

 

[daddy]

Damn...I was worried you guys were going to say that.

They are Weld Dunes.

Yeah, you'll be very bowlegged with those measurements. That's a pretty busy wheel.

 

[Bowtie2Sierra]

I didn't make it far enough to look into tires. I had a hunch the wheel width & offset wasn't going to work since I don't want much of a lift (if any).

 

[Bowtie2Sierra]

Yeah, you'll be very bowlegged with those measurements. That's a pretty busy wheel.

It's always been one of my favorite wheels. But I'm not sure it was ever made in a size that would work for what I want. I'd like to have something stick out no more than 1/4" inche from the fender.

 

[RebelThunder]

Ask on GMFS, they are all about running wide wheels over there.

 

[Bowtie2Sierra]

I've talked to a few guys over on GMFS and the consensus is that I need at least a 6in lift.

You are right about those guys though...they think a 20x10 is narrow. It seems like they are all about 20x12.