Matt_
I'm "nobody" to Rob...
Looking to do an autocal soon on my 2012 Yukon XL 2500 and have some questions...
Can the 6L90E trans also be tuned?
I was just going to have the 87 octane tune adjusted, TM removed, trans tuned, etc.... but the more im reading about the L96, the more it seems like this engine should really be run with a higher grade of gas; they basically spec it for 87 for fleet use. So is an 87 tune even worth it? Figure if the computer may already be pulling timing, there will be little benefit of tuning for that grade.
Any experience on which grade gasoline is best, going for an all around DD for now... not racing and not towing a heavy load. 89 or 91? I think the truck has seen WOT maaaybe once... its not something i like to do.
Anything i can do ahead of time with my scanner? Maybe looks to see if knock sensor is picking up detonation and bump up the grade of fuel until it doesnt? If I do that, and say its good with 89, would it be best to tune it for another grade higher, or is this something that you assess when I do the data recording with the autocal to send in for the tune?
Thanks!
Can the 6L90E trans also be tuned?
I was just going to have the 87 octane tune adjusted, TM removed, trans tuned, etc.... but the more im reading about the L96, the more it seems like this engine should really be run with a higher grade of gas; they basically spec it for 87 for fleet use. So is an 87 tune even worth it? Figure if the computer may already be pulling timing, there will be little benefit of tuning for that grade.
Any experience on which grade gasoline is best, going for an all around DD for now... not racing and not towing a heavy load. 89 or 91? I think the truck has seen WOT maaaybe once... its not something i like to do.
Anything i can do ahead of time with my scanner? Maybe looks to see if knock sensor is picking up detonation and bump up the grade of fuel until it doesnt? If I do that, and say its good with 89, would it be best to tune it for another grade higher, or is this something that you assess when I do the data recording with the autocal to send in for the tune?
Thanks!
