Nice, thanks for doing the write up Matt.
BEDRUG and TruXedo LO PRO QT Install
- Thread starter Matt_
- Start date
Nice. What happened to the folding one? You finally sell it?
Oh, and I see you finished the downstairs room since Rob and I were there last year. No more peanut shells just chilling on the concrete floor.
Oh, and I see you finished the downstairs room since Rob and I were there last year. No more peanut shells just chilling on the concrete floor.
Matt everytime I see these pics I want to go spend some money.
As soon as I have some extra funds, I am going to own a bedrug.
Looks great man!!
As soon as I have some extra funds, I am going to own a bedrug.
Looks great man!!
Matt_
I'm "nobody" to Rob...
Nice. What happened to the folding one? You finally sell it?
Oh, and I see you finished the downstairs room since Rob and I were there last year. No more peanut shells just chilling on the concrete floor.
Yup, sold the BakFlip.
And im in the process of getting some kickass furniture for downstairs... you guys are going to have to come by and hang out
OldCracker29
I've been knocked down drug out and left for dead
That looks great. My wife would've had my nuts in a sling if I had that in the house.
07blackz71
Change is always Good!!!
Looks good!!!
For the rear seal, Could you add another piece of rubber going out over the tailgate to eliminate the water issues?
For the rear seal, Could you add another piece of rubber going out over the tailgate to eliminate the water issues?
Matt_
I'm "nobody" to Rob...
You probably could if you wanted to. It's not really an issue though, the bed and the tailgate were dry... just the little bit of material that goes into the tailgate/bed gap was moist. Not really a bid deal to me..
elcompaLalo
Whats a custom user title?
Great write-up of two very nice products!
I have the truxedo low pro cover also and you will lose those stupid rubber bumper pieces. I have lost a few. Second. My rails were starting to bow in the middle. so the two ends would be flush with the bed rail but the middle would be a quarter to a half inch lower. I fixed this by actually drilling and putting some nuts and bolts to hold it flush.
