Anybody know how to get pins out of headlight sockets?

[Carolinaboy]

I need to switch around two of the prongs going into my H13 Male socket from my HID harness for my Retrofits

Here is a picture reference go down to the bottom and look at the H13

They tell you to switch prongs around but I have no idea how to get them out

http://www.theretrofitsource.com/pdf/trs_tech/Heavy_Duty_Bi-xenon_Harness.pdf

Ideas? I really wanted to finish these retrofits tonight No one has responded to any of my posts over on their forum, it's been 3 hours.....very helpful

 

[Boilerup15]

I'm guessing they just pull out with some force.

 

[Carolinaboy]

Nope

 

[Kennyray]

I believe you will have to go between the housing and the pin with a small jewlers screwdriver to release them.

 

[Boilerup15]

They do make a little tool on some harnesses that you slide back towards it and releases it somehow.

 

[Carolinaboy]

I believe you will have to go between the housing and the pin with a small jewlers screwdriver to release them.

Yeah I've been trying that for hours literally! Guess I'll have to call tech support in the morning

 

[dirtyoldman]

Try using a small paper clip with a flattened end...the locking tab is visible on the last pic.I'm guessing you'll have to stick the paper clip in from the pin end,not the wire end.

 

[Carolinaboy]

Cool, yeah that's what one other guy said, but a safety pin. I'll try that thanks!

 

[dirtyoldman]

Look real close,there might even be a little groove where the locking tab fits into..

 

[Cowboy Cadillac]

Use a small screwdriver/paperclip/what have you and come in from pin end to release the catch tab and it should slide ride out. Had to do same thing with fuel pump wiring on a buddys truck recently.