Tahoe (GM) Steering Wheel Controls ??

agjake11

Oral the Coal
Joined
Jan 23, 2010
Posts
8,446
Reaction score
0
Location
Rosenberg/Beaumont TX
probably a simple answer to this but out of curiosity should all the steering wheel control buttons be illuminated? tahoe only lights up the "enter" button on the wheel at night.

7807e10d.jpg


and just for fun pic of dirty hoe tinted by ford :jester:

cd44e8ac.jpg


2e0550ec-1.jpg
 

txab

Don't get stuck on stupid!
Joined
May 28, 2009
Posts
3,640
Reaction score
57
Location
Texas
IIRC you'll need to replace the switches
 

agjake11

Oral the Coal
Joined
Jan 23, 2010
Posts
8,446
Reaction score
0
Location
Rosenberg/Beaumont TX
in that case. i think itll just stay as is. i might take it off and check the wires but have a feeling switches wont be cheap
 

txab

Don't get stuck on stupid!
Joined
May 28, 2009
Posts
3,640
Reaction score
57
Location
Texas
did some looking they can be replaced. I did have a link to repair instructions, but the link is dead now. I'll do a little more looking

Ebay has switches was like for about $25 shipped. $100 for all 4.


Edit:

Found this:

disconnect the battery, wait 5min (for the airbag) remove the airbag, pop out the buttons from inside the wheel, they are just pushed in the spokes of the wheel. The only problem getting them out is with the wire harness attached to them. It's short so you have to carefully wiggle them around to get them out far enough to get to the wire harness. Once you have them out you can carefully dissassemble them (they are just clipped together, pop out the circuit board where the bulbs are soldered on. Use a small soldering iron to remove the bulbs and don't lose the little white sockets from the bulbs (you will re-use them). Radio Shack should have some micro lamps # 272-1092 (two per pack and each button contains two bulbs). Re-attach the bulbs to the sockets, (there will be two styles of sockets used if you do them all) and re solder them to the boards.
 
Last edited:

agjake11

Oral the Coal
Joined
Jan 23, 2010
Posts
8,446
Reaction score
0
Location
Rosenberg/Beaumont TX
thats not too bad. i will get grief from the wife over wanting to mess with the tahoe but i want to bring it completely back to working order and this is one of those little things that needs fixing.

dont stress over looking around for one though
 

txab

Don't get stuck on stupid!
Joined
May 28, 2009
Posts
3,640
Reaction score
57
Location
Texas
See if Scotty has done this. I know he replaced his door panel switch bulbs with LEDs
 

Staff online

Members online

Latest posts

Forum statistics

Threads
28,836
Posts
1,109,352
Members
4,800
Latest member
SpeakerMan
Back
Top