It's time for another wheel thread

[Zembonez]

I do like the Enkei wheels.

 

[Bowtie2Sierra]

I like those Enkei wheels too. Hmmm...I'll have to check them out closer. Between the two, I like the Enkei RT6. Thanks for posting those JD.

I hope one of the options is to get them with a smooth edge on that lip.

I just got off the phone with Centerline and they can make a set with a smooth edge on the lip. They don't have any pictures of the Bigfoot in a 6 lug yet because they haven't made any yet. They are going to make a wheel for picture purposes but he didn't know when that would be done. I guess I would be the first to have a set made. Instead of the 8 spoke in the 8 lug, he was pretty sure it would be 6 spoke for the 6 lug. They will be right at 32lbs for 20x8.5.

Just to beat a dead horse to death, does anyone see any issues with running this wheel with +12 offset with only a leveling kit?

 

[CJ Hungus]

I like those Enkei wheels too. Hmmm...I'll have to check them out closer. Between the two, I like the Enkei RT6. Thanks for posting those JD.

I hope one of the options is to get them with a smooth edge on that lip.

I just got off the phone with Centerline and they can make a set with a smooth edge on the lip. They don't have any pictures of the Bigfoot in a 6 lug yet because they haven't made any yet. They are going to make a wheel for picture purposes but he didn't know when that would be done. I guess I would be the first to have a set made. Instead of the 8 spoke in the 8 lug, he was pretty sure it would be 6 spoke for the 6 lug. They will be right at 32lbs for 20x8.5.

Just to beat a dead horse to death, does anyone see any issues with running this wheel with +12 offset with only a leveling kit?

32bls... mine were right around 23lbs. for my centerlines. And I will never do business again with those guys.

 

[Bowtie2Sierra]

Yeah most if their other wheels are listed as weighing less so these are definitely heavier. Everything else I'm looking at is around 40lbs so I'm happy with 32.

I remember the problems you had. I'll roll the dice if I decide on these.


Sent from my iPhone using Tapatalk

 

[Zembonez]

+12mm offset is going to stick out a bit and increase the likelihood of rubbing the inner fender when turning. Mine are +36mm and they fit almost perfectly flush with the fender lip.

 

[Bowtie2Sierra]

Are your wheels 8.5" wide?

I can also get them in a +30mm or 32mm offset (can't remember which). The only reason I was leaning towards +12mm was for a little deeper lip.

 

[Zembonez]

Might be deeper but it won't look right on the truck sticking out (in my opinion)

 

[daddy]

Might be deeper but it won't look right on the truck sticking out (in my opinion)

12 might be a bit much. My old Sierra was 18 and perfect with 305's.

My old Blue Sierra setup

Size: 20x8.5

Lug Pattern: 6x5.5

Offset: 18

Back Spacing: 5 7/16"

 

[Zembonez]

Mine are 9 inches wide and +36. That translates into 18mm LESS outside the hub than the +12 8.5 inchers he posted. 18mm will certainly stick out past the fender... but I'm incredibly anal about wheels being flush or just inside.

 

[RebelThunder]

On a 4 wheel dig truck, aftermarket wheels should stick just past the fender IMO.