Replacement Dust Boots-Funniest Thread This Week

[davbell22602]

Does anybody know to get replacement dust boots for the tie rods and drag link? I checked LMC, NPD, Truck Shop, Rockauto and Dennis Carpenter. Isnt tie rod dust boots the same size as drag link dust boots on 67 F100 2wd?

 

[RedRider]

These?

http://www.autopartswarehouse.com/s...13101G.html?tlc=Brakes,+Suspension+&+Steering

 

[davbell22602]

Are they same size as the ones that used on the center link/drag link?

 

[RebelThunder]

Are they same size as the ones that used on the center link/drag link?

I'm not sure. Let me run out to my '67 Ford and take a few measurements and compare the measurements to the ones on the website. Be right back.

 

[Bigredmariner]

Are they same size as the ones that used on the center link/drag link?

I'm not sure. Let me run out to my '67 Ford and take a few measurements and compare the measurements to the ones on the website. Be right back.

Well, what did you come up with Scott? Are they the same? Huh?

 

[daddy]

 

[RebelThunder]

Are they same size as the ones that used on the center link/drag link?

I'm not sure. Let me run out to my '67 Ford and take a few measurements and compare the measurements to the ones on the website. Be right back.

Well, what did you come up with Scott? Are they the same? Huh?

Well I didn't feel like crawling on the ground so I pulled it into my shop where I got the 4 post lift. Got it in the air and and a few seconds before I went under to take a look, the sumbitch fell off the lift. Had to come and and change my underwear and call OSHA so they could come investigate the situation tomorrow. Needless to say I didn't get any measurements.

 

[canuckz71]

http://en.m.wikipedia.org/wiki/Tape_measure

 

[daddy]

Are they same size as the ones that used on the center link/drag link?

I'm not sure. Let me run out to my '67 Ford and take a few measurements and compare the measurements to the ones on the website. Be right back.

Well, what did you come up with Scott? Are they the same? Huh?

Well I didn't feel like crawling on the ground so I pulled it into my shop where I got the 4 post lift. Got it in the air and and a few seconds before I went under to take a look, the sumbitch fell off the lift. Had to come and and change my underwear and call OSHA so they could come investigate the situation tomorrow. Needless to say I didn't get any measurements.

Weak.

 

[RebelThunder]

You got better?