Search results

  1. lilfroger

    Dodge 3rd Gen Dash cluster bulbs

    To replace the HVAC Control light's on a 3rd Gen The dash bezel must come out Removal of Dash Bezel 3 Mopar Dash lights (part # 05013815AA) must be purchased from dealership. Thanks to Dave at James O'Neal Dodge for the prompt delivery! From the back of the HVAC control the 3 bulbs...
  2. lilfroger

    Dodge 3rd Gen Wet Okole Seat covers

    Purchased Seat covers direct from Wet Okole Ordering Note ** If you order a vivid or unusual color even if you select no swatch ... they will send you a swatch and they will wait to process your order until you call and confirm. You will also get a call concerning your order as the on-line...
  3. lilfroger

    Cobra 19 DX IV Dodge 3rd Gen Install

    To Remove dash bezel see: DIY - Removing / replacing your 3rd Gen radio bezel. Purchased a Cobra 19 DX IV. This radio was chosen for it's small footprint: Length: 7 Width: 4.5 Height: 1.75 A new bezel was obtained from Dave via James O'Neal Dodge. The stock unit could have been used; but...
  4. lilfroger

    Looking back... the journey thus far

    Build date: 07/06 Brought home: 10/06 Jake installed: 12/06 First boo-boo: 01/07 (slid down icy hill banged up drivers side door ... and yes the husband was driving :crackup:) First tires: 05/07 tires and level First exhaust mod: 07/07 tip & straight pipe Stripped naked: 10/07 Black...
  5. lilfroger

    Air Ride & Bilsteins installed

    I've been grumbing for some time now that my shocks were shot. It's been on the to do list. We also wanted to add air bags to the rear for when we are towing though. So it's taken a bit to get everything together to get all 4 shocks and the rear bags. But alas they arrived last week. It's...
  6. lilfroger

    Installing LED on 06 & up Dodge

    Because of a new TIPM used on 06 and newer Dodges when adding LED lights in lien w/ OEM lights a 6 ohm 50 watt power resistor must be wire in Parallel. Attached is the diag and info on how to wire in so lights continue to work.
  7. lilfroger

    Need a Dodge Wiring Diag?

    The place to go look for 04 and newer Dodges (Rams, Dakotas, Durangos, and Caravans) is http://www.dodge.com/en/business/body_builders_guide/ Pick your component it's in there
  8. lilfroger

    DODGE DIY - Air Dog II Install

    Tools Required: 18mm deep socket and ratchet 10mm wrench 3/8 wrench 5/16 wrench 5/16 allen wrench 9/16 wrench flat blade screwdriver Loctite 2760 (small amount provided in kit but more was needed): insure all threaded fittings are loctited. Lubricant for barbed ends of all push lock...
  9. lilfroger

    DODGE DIY - 318 Plenum Reinforcement kit install

    Install Vehicle: 99 Dodge Ram 1500 318 **same engine used in Dakota's, Ram vans, Durango, Grand Cherokee** Reason for install: vehicle was loosing oil but no visible oil leak was found, vehicle had jumpy idle, vehicle had sluggish throttle response Dodge TSB 09-05-00 was issues for this...
  10. lilfroger

    DODGE DIY - Rear Bumper Lights

    Here is the parts list: 2ea. #4411 lights from Napa (auto quest also uses the same part numbers) - the lights in my pictures are actually from a Semi service place locally cause we broke one of the 4411 lights on install. 2 4 inch rubber light grommets 1 relay, one three position switch 2...
  11. lilfroger

    Oh I'll share my scoot porn too

    If I'm not in the CTD I can be found on my Sport. 08 883 Sportster ~ parked w/ just over 4k on the ODO right now. Can't wait for the weather to calm down a bit so I can pull him out again :D Family Ride:
  12. lilfroger

    CTD Block Heater Specs

    The block heaters is installed on all trucks; just most do not come with the cord.* An optional engine block heater is available with all models. The heater is equipped with a power cord. The cord is attached to an engine compartment component with tie-straps. The heater warms the engine...
  13. lilfroger

    DODGE: How to retrieve CEL code w/o programmer

    To retrieve codes with out a 3rd party programmer - Insert key and turn from off to on (with out starting) 3 times. Any codes will display on the ODO. This is not fool proof 100% of the time. It will take several attempts ... do not give up if you do not get DONE or a Code. Known situations...
  14. lilfroger

    DODGE: How to Clear "Change Oil" Message

    The oil change indicator system is being introduced on most 2008 models. This system displays a "Oil Change Required" or "Oil Change" message at appropriate intervals on the instrument cluster. To clear message after properly changing oil at required intervals: 1 - Insert key and turn to...
  15. lilfroger

    I can't be the only coal burner

    Can I ? Jumped through a handful of these pages and I'm seeing Hemi's abound ... no CTD though :( Really no one else slipp'n clutch packs and running boost numbers off 32lbs? Come on please tell me there is at least one more ... Or do I need to bust out the Dakota?
Back
Top