Recent content by Wyley87

Install an airdog 4g in the service truck. Sent from my SAMSUNG-SM-G930A using Tapatalk

Installed the leather wrapped steering wheel in the service truck today. Complete with audio controls. Truck already had cruise. Loving it. Sent from my SAMSUNG-SM-G930A using Tapatalk

Oh and installed dic controls Sent from my SAMSUNG-SM-G930A using Tapatalk

Got the dexcool out of my work truck. Sent from my SAMSUNG-SM-G930A using Tapatalk

I got a helicoil kit. Didn't have to drill out the hole it was already the right size. All is good now just need to put the fender well back in. I've been busy at work and when I'm not busy I'm busy. :D Sent from my SAMSUNG-SM-G930A using Tapatalk

I was thinking that too. It's just a long bolt that I think go's through the timing cover. Has to be 4-5 in Sent from my SAMSUNG-SM-G930A using Tapatalk

05 xterra 2wd 4.0 I was following Nissan TSB NTB06-072b checking/replacing the serpentine belt auto tensioner. Long story short their diagram shows to torque the lower bolt on the power steering pump to 42-48ft lbs. When I went to torque it the bolt ripped the aluminum threads out. Later I...

I'm so ordering one! ;) Electric SuperChargers Mythbusted: http://youtu.be/cbGWgvJN1_8

Agreed.

I think my dads 4l80 has that dimple but on his it's a drain plug

Nice. I was thinking of putting in a second sensor with a toggle switch.

Bottom view of the pan I have. I putting mine in the top left dimple.

JB weld? :jester:

So plan B auto meter wants $11 plus shipping fir the weld in bung. So I ordered a drain plug kit but I'll use a copper crush ring instead of the nylon washer. No to figure out where to drill that hole.