1972. The ignition switch is from a earlier model jeep. Don't know why. But I don't think it should make a diff, right?
I know that I'm not getting that. But I have no idea how to fix that. Any pointers? All the wires look good. Only wires that should be of concern...
I don't. Is this the pain in my ass that is so easy to fix? Maybe?
I've done both. Bought a new ignition switch, and I've used a jumper wire. Jumping from starter solenoid, to the ignition switch. And still...
Only thing I might have wrong is the small red to a "12 volt switched" source. If that can be clearly defined to what I should run it to might...
6 AL
Tried both SIGNAL & IGNITION to the ignition, it cranked up, semi started but starter gear wouldn't disengage. I've read msd instructions online...
Update: with previous set up applied, (ignition switch all wired normally) I accidentally jumped the ignition wire (runs out of msd ignition box...
Tracing all the wires, and checking the wiring diagrams, there is no starter relay? And the very small amount of fuses that are in place all...
Caused myself some problems, ended up not being able to start the truck. Fast fwd 3 days, got everything wired back up, new ignition module,...
Ended up chasing wires all damn day. Cut open all the wound up electrical taped garbage that was the electrical system. Found about 10 dead ended...
Been doing research on msd website. Got a couple trouble shooting plans to do later today. Tried the first one just now, didn't get any spark....
I've got 35" BFG KM2 on it. Ran it today for first time since I got it back. Took it up the Strand, cruised between 2k/2500rpm and I seemed to be...
So, pulled the diff cover and the stamped numbers are 41-11 = 3.73 gears. I'm going to try and post some pix of all the numbers stamped everywhere...
Separate names with a comma.
